Alternating current MCQs for MDCAT

Alternating current is chapter 12 of 14 in the PMDC MDCAT Physics syllabus. Below are 3 sample MCQs with answers and explanations. The full bank has 41 questions on this chapter.

Sample questions

Q1An alternating current is one that

  1. Avaries sinusoidally and reverses its direction every half-cycle
  2. Bflows in one direction with a constant value
  3. Cflows in one direction but in pulses
  4. Dincreases steadily with time
Show the answer and explanation

Answer: A. varies sinusoidally and reverses its direction every half-cycle

An alternating current varies with time as a sine (or cosine) function. It rises to a peak, falls to zero, reverses direction to a negative peak and returns, so its direction reverses every half-cycle. The peak value is the same in every cycle.

  • B is wrong: A current that flows in one direction with a constant value is direct current (DC).
  • C is wrong: Current in one direction in pulses is pulsating DC, such as the output of a rectifier.
  • D is wrong: A current that keeps increasing never reverses, so it is not alternating.

Q2The mains supply in Pakistan has a frequency of 50 Hz. What is its time period?

  1. A50 ms
  2. B20 ms
  3. C2 ms
  4. D0.5 s
Show the answer and explanation

Answer: B. 20 ms

The time period is the reciprocal of frequency: T = 1/f = 1 ÷ 50 Hz = 0.02 s. Since 1 ms = 10⁻³ s, this is 20 ms. So the mains supply completes 50 full cycles every second, each lasting 20 ms.

  • A is wrong: 50 ms would be the period of a 20 Hz supply, since 1 ÷ 0.05 s = 20 Hz.
  • C is wrong: 2 ms would be the period of a 500 Hz supply, since 1 ÷ 0.002 s = 500 Hz.
  • D is wrong: 0.5 s would be the period of a 2 Hz supply, far slower than the mains.

Q3During one cycle of a sinusoidal alternating voltage, where does the voltage change most rapidly?

  1. AAt the positive peak
  2. BAt the negative peak
  3. CAt the zero (crossover) points
  4. DIt changes at the same rate throughout.
Show the answer and explanation

Answer: C. At the zero (crossover) points

The rate of change of a sine wave is given by the steepness of its graph. The curve is steepest where it crosses zero, so the voltage changes most rapidly at the zero (crossover) points. At the peaks the curve is momentarily flat, so the change is slowest there.

  • A is wrong: At the positive peak the curve is momentarily flat, so the voltage changes most slowly there.
  • B is wrong: The negative peak is also a flat turning point, so the voltage changes most slowly there too.
  • D is wrong: The slope of a sine curve changes continuously, from steepest at zero to flat at the peaks.

Topics in these questions: AC and its characteristics.

More Physics chapters